User contribution: The cheapest way to clean a sexualdoll after you have sex with an adult doll

Cleaning the vagina or various passages of a sexualdoll is very important for the maintenance of an adult doll. But since the doll is very heavy, especially after you ejaculate, you are sleepy and you may be too lazy to do it. Today, a customer introduced his cheap and easy way to clean silicon sexdolls.

Clean sexualdoll needs to prepare

Basin: It is recommended to use a stainless steel basin, which is more durable and safer. The diameter should be about the width of your adult doll‘s hips. This is it:

Water sprayer: Generally, sellers will give one for free when shipping the product, but the water pressure is not enough. I recommend using this one, which has a stronger water flow.

Cup brush: The selection criteria are that it should be as thin as possible, relatively straight throughout, without protruding parts, longer than the depth of the sexual doll’s vagina, and the diameter of the sponge head should be similar to the width of the adult doll’s vagina after opening. If it is too big, trim it yourself with scissors.

Kitchen paper towel: Note that it is not facial tissue. This category is called kitchen paper towel. Its characteristics are water absorption and not easy to break after being wet. The selection standard is that the width must be greater than or equal to the depth of the realistic sec dolls channel.

Diatom sticks: Most adult doll manufacturers will give this away for free, but this is a consumable item, so you also need a spare part.

Start cleaning sexualdoll

Place the waterproof mat and washbasin under the adult doll’s butt. This can be done in two steps: first place the waterproof mat, then place the washbasin.

Open the legs of the doll and start washing. Don’t open them too wide to prevent tearing. Rinse with water several times first, and the water will flow out by itself. After making sure that the inside is fully washed, use a cup brush to clean it. Be careful not to use too much force and twist it in.

Turn the cup brush and if it feels a little rough after a few strokes, it means that the lubricant on the inner wall has been cleaned off. Pull out the cup brush and continue flushing.

One cleaning uses about the amount of water of a pot. After flushing, hold the baby up with the upper body upright to ensure that as much water as possible flows out. Here we use a small baby as a demonstration.

Make sure there is almost no water in the sexualdoll, lay the doll flat, remove the washbasin, and prepare to dry it.
Then take an appropriate amount of kitchen paper towels. This depends on the paper you bought. You can estimate it yourself. Anyway, you can add more if it is less.
After folding it, roll it up with a stick. Don’t roll it too tightly, otherwise it will be difficult to pull the stick out later. Roll it to a diameter slightly wider than your finger, leaving a little on the head and fold it up.
Then insert it into the channel of the adult doll. Be careful not to force it in, but rotate it in.

Then put the sexualdoll’s legs together and let it sit for about 10 minutes.
Then open the legs and take out the tissue. Be careful not to let the paper break inside. If it is difficult to pull it out directly, rotate it to take it out.
The first tissue is used to absorb water. After taking it out, you will find that it is still relatively wet. Roll a new paper and put it in. Open the legs and rotate it again.
Generally, it will be enough to absorb it two or three times. Take it out to see how wet the paper is. After ensuring that almost no water can be absorbed, insert the diatom stick, rotate it, put the legs together, leave it in the body for two or three hours, and then take it out. At this point, the cleaning is complete.
Be careful not to leave the diatom stick in the adult doll for a long time. If you put the diatom stick directly in after washing and don’t use it for a long time, it may get moldy.